MAINTENANCE
14
After Use
1.Always clean the Seawolf Ocean Master thoroughly with freshwater after each use. It is recommended to operate the
pump and motor in freshwater for couple seconds.
2.Remove the Seawolf Ocean Master from freshwater and let motor rotate at high speed to dry the motor.
Periodical Check
1. Please check pump and water tubes regularly and make sure that they clean & flexible without any cracks or holes
Recommend to change all Tubes and O-rings every 6-month for best performance.
Contact authorized dealer for after service.
2. Make sure the pump operates smoothly and nothing blocks the inlet.
3. Remove the outer hull panels and clean every part.
4. Before storing the Ocean Master for a long time keep the inner hull open and disconnect the fuse.
5. Check the fail safe system (switch off the controller and see if the protection system activates).
6. Check the low battery safety system.
7. Check the integrity of inner hull. No cracks on inner tube.
8. Check there is no leakage from the inner linkages and tubing.
9. Check the dive planes and rudder operating angles. Adjust control rods and trims if necessary.
10. Check the O-Ring status with correct tightening.
11. Check operation of the switches and of all the other water proof exits.
