6
Charge
Function
1. Press "Power" for 5 seconds to turn on the monitor.
2. The monitor screen should pick up the signal from
Seawolf Ocean Master immediately. If not, check all the
connections are connected correctly and firmly as page-9
shown, then perform the following setting.
3. Press "return" to make sure in video mode.
MONITOR
1. Install the proper power plug on the switching adaptor in
place. Make sure the plug is all the way in.
2. Connect the charging plug to the charging jack of the
monitor at left.
3. Start to charge the monitor, the LED indicator will be in
Red. Once it full charged the LED light will turn off.
4. Press "Manual" (The third button from the right) to enter
manual setting.
5. Use "<" and ">" button (The second and third bottom from
the left) to select manual's category.
6. Select "Function" category from the manual list. Which is
the third category from the top.
7. Press "Enter" (The third button from the right) to enter the
category.
8. Press "< "or ">" to choose the sub-category. Choose
"System" sub-category by press "Enter" (The third button
from the right).
9. Use "<" and ">" button to select "NTSC M". Press "Enter"
(The third button from the right) to select it.
10. You should able to see the live video stream from the
Seawolf Ocean Master now.
11. Press "return" (The second button from the right) twice to
exit the categories.
