TSI Quest EDGE EG-4P, Руководство пользователя

Страница: 53 / 88

Running and Operating your Dosimeter 4-7
R u n n i n g S t u d i e s
With a couple pushes on the keypad buttons, you will be running and
viewing your study(ies). Following your study(ies), you can load the
data/files into DMS to manipulate, analyze, save, and create reports
(See
Chapter 5 for viewing your logged data in Detection Management
Software).
Starting a Run

How to Run a Noise Study
1. If your dosimeter is turned off, press the on/off enter button to
power on.
2. Press and hold the run/stop button.

A 3, 2, 1 countdown will appear.
3. When running, the following will appear:

A run indicator will appear on the top-right side.

The LED indicator will flash green (unless you disabled this in
DMS.)
Measurements

Use up/down arrow to
move through values.

Views are
customizable via
DMS setup.
Flashing green LED
Indicates running
Battery indicator
Run indicator
Appears when running
Figure 4-8
Display screen while running
S t o p p i n g a S t u d y
While the dosimeter is running, you can end the study by pressing and
holding the
stop button.

How to Stop a Noise Study
1.
While running, press and hold the run/stop button .
a. A 3, 2, 1 countdown will appear.
b. The stop indicator
■
will be shown in the display.