TSI Instruments 9510, Инструкции по эксплуатации

Страница: 23 / 89

Getting Started 2-5
To Install the Lithium-Ion Battery
1. Remove the battery door on the back of the instrument by
turning the two thumbscrews counterclockwise.
2. One battery is provided for the 28.3 and 50 L/min models, but
up to two batteries can be used to extend the run time. Two
batteries are provided for the 100 L/min model (Model 9500)
and both must be present for the unit to operate on batteries.
This is due to the larger power draw at the 100 L/min
setpoint. Slide the battery into the slot (it doesn’t matter which
one), pressing until it is flush with the back panel (note the
orientation of the tabs).
3. Replace the battery door and secure with the two
thumbscrews.
4. The batteries will be charged if the instrument is on and not
actively taking a measurement. If you use the unit with
batteries often, you might also consider using the TSI external
battery charger (see
Optional Accessories
in Chapter 1).
Note
: It is also possible to “hot swap” batteries if you are
careful. As long as one charged battery is engaged at all
times, a fully charged battery can be inserted and then
the depleted battery removed without powering down
the unit.
!
W A R N I N G
The battery supplied by TSI (PN 1208057) has built-in protection against
explosion and fire hazard. Do
not use a substitute.
Do
not use any other type of battery in this instrument. Fire, explosions,
injuries, or other hazards may result.