TSI Incorporated SIDEPAK AM510, Руководство пользователя

Страница: 34 / 74

Chapter 3 26
the amount of memory required by manipulating the
following protocol parameters:

Increase the logging interval.

Decrease the time (length) for the test.

Decrease the number of tests.
Note : For proper operation, the settings for each Prog
mode must not require more than 100% of the
logger memory. If the
Percent memory required
is greater than the Available memory , the logging
instrument automatically stops the test when
memory is full.
4. When you have finished defining the parameters for Prog
1 and Prog 2 modes, select
Send . The software confirms
that the instrument was programmed properly.
5. You can now disconnect the SidePak monitor and cable
from the computer.
Example Setup for Prog 1 and Prog 2 Modes Using
TrakPro
Software
The following example describes how to program Prog 1 or
Prog 2 mode tests.
The protocol for Prog 1 is set to take unattended aerosol
readings for one day, 09/01/2008. The logging sample begins
at 8:00 a.m. and continues for eight hours.
The protocol for Prog 2 is set up to take unattended aerosol
readings for two days, beginning on 09/01/2008. Logging
begins at 8:00 a.m. and continues for eight hours. The
instrument is off for 16 hours, and then repeats the eight-hour
test on the following day.
The following graphic shows the dialog box displayed in the
TrakPro software, with these particular logging parameters.