TSE T50 BWRC, Руководство пользователя, Страница: 111 / 129

-68-
Be sure to use only the fasteners matched to the cone angle of
your wheel (usually 60
o
or 90
o
). The proper procedure for
attaching your wheels is as follows:
1. Start all bolts or nuts by hand to prevent cross threading.
2. Tighten bolts or nuts in the sequence shown for Wheel
Torque Requirements.
3. The tightening of the fasteners should be done in stages.
Following the recommended sequence, tighten fasteners
per wheel torque chart below.
4. Wheel nuts/bolts should be torqued before first road use
and after each wheel removal. Check and re-torque after
the first 10 miles, 25 miles, and again at 50 miles. Check
periodically thereafter.
Wheel Torque Requirements
(For Dexter Steel Wheels Prior to June 2004)
Wheel Torque Sequence
Size 1st Stage 2nd Stage 3rd Stage
12" 20-25 35-40 50-75
13" 20-25 35-40 50-75
14" 20-25 50-60 90-120
15" 20-25 50-60 90-120
16" 20-25 50-60 90-120
16.5" x 6.75" 20-25 50-60 90-120
16.5" x 9.75" 55-60 120-125 175-225
14.5" Demount. Tighten sequentially to 85-95
17.5" Hub Pilot 50-60 100-120 190-210
Clamp Ring & Cone Nuts
17.5" Hub Pilot 50-60 90-200 275-325
5
/
8
" Flange Nuts
4 BOLT 5 BOLT 6 BOLT 8 BOLT
1
1 1
1
2
2
2 2
3
3
3
3
4
4
4
4
5
5
5
6
6
7 8
Wheels and Tires