Doc. # 5016
BM-185D/285D/286D
Rev. A
Operation and Service Manual
3.4.1.16 Notify User if SCALE Drifts
If enabled, allows the user to enter the amount of drift that is allowed by the monitor before it
informs the user that a hardware tare is recommended. A value of zero disables informing the
user about scale drift.
3.4.1.17 TARE Scale Type
Allows the user to select if a TARE is going to be done through Software or Hardware.
3.4.1.18 Intermec Printer Support
If enabled, will allow the printing of labels sized specifically for Intermec printers.
3.4.1.19 Display Negative Scan Results
When selected, all values whether positive or negative that are part of the Scan sum will be
displayed.
3.4.1.20 Prompt for Waste Item ID Before a Scan
If disabled, a "WASTE ITEM ID" prompt will not be displayed when performing scans.
3.4.1.21 Enable Scale Auto-TARE And Drift Alerts
When selected, this feature causes the scale to automatically TARE at startup and also activates
the user selectable amount of drift allowable before a Drift Alert is activated.
3.4.1.22 Enable Two Energy Windows on Waste Streams
Allows the user to adjust two sets of discriminators in order to establish both a low and a high
energy window.
3.4.1.23 Disable Scale Controller and SPACT Alarm Logic
If a BM-285D has no scale, selecting this feature will provide a way for the user to manually
start a Scan.
3.4.1.24 Use MDA Calculator for Dynamic Alarm Levels
Provides an automatic way for the system to calculate the minimum alarm threshold and adjust
for changing backgrounds.
PAGE 27
