Doc. # 5016
BM-185D/285D/286D
Rev. A
Operation and Service Manual
2.0 INSPECTION AND INSTALLATION
2.1 INSPECTION
2.1.1 Incoming Inspection
Immediately inspect the system for mechanical damage, scratches, dents, or other defects. It
should be examined for evidence of concealed damage, as well as external disfigurement.
2.1.2 Damage Claims
If the system is damaged in transit or fails to meet specifications upon receipt, notify the carrier
and TSA Systems immediately. Shipping cartons, packing materials, waybills, and other such
documentation should be preserved for the carrier's inspection. TSA will assist in providing
repair or replacement of the system as necessary.
2.1.3 Storage
Care should always be taken to avoid subjecting the system to severe mechanical or electrical
shock. The system should be stored in a dry location and in a temperature range of 0 to 50°C.
2.1.4 Shipping
Before returning the system for any reason, notify TSA Systems of the difficulty encountered.
Please be prepared to give the model and serial numbers of the equipment. TSA will furnish
precise shipping instructions.
2.2 INSTALLATION
The system is complete and ready to operate when it is shipped. The tablet PC, stored inside the
chamber, must be mounted to the system. Mount the PC with the screws provided on the right
side and connect the following cables.
System AC
Speaker
PC AC
SC-770 Controller RS-485
The power cord located on the right of the unit plugs into a standard 100-240 volt, 47-63 Hz ac
receptacle provided on the controller enclosure. When the system is installed at its operating
location, perform the set-up described in section 3.1. General Overview should be performed.
PAGE 11
