TS Industrie Super Premium 30ER, Техническое руководство

Страница: 22 / 76

Super Premium 30ER / 35DR / 35DRI
22
23/01/2014
WARNING!
If for an unknown reason the shredder has difficulty shredding the matter, and that
you have to stop it:
do not start the engine again without having eliminated the
cause and cleared the matter out of the shredding rotor!!!
PUTTING IN SERVICE
1) Check that the cap at the end of the shaft is
open.
2) Slightly accelerate the engine’s throttle lever
- engage the starter on petrol model
Start the engine with the ignition key preheating
on the diesel model
- preheating on the diesel model
The starter can only be activated if the
preheating light is continuously lit
(on rectangular
control panel),
or extinction of light
(on square control panel).
- remove the starter (petrol)
Accelerate the engine to mid-speed and let it
warm up
Model and ER DR: see text in black frame page 46
Make sure the cutting rotor is placed in rotation
and that it is not jammed by residue of matter
that would prematurely damage the centrifugal
clutch.
(see advice when stopping on next page )
Engage gradually and lock the clutch:
-lever up to the DR version
down to the DRI version ( )
Accelerate the engine’s speed to bring it to its
maximum speed.
Put the feed roller in rotation by activating the
yellow control pusher located on the rear left of the
branches intake hopper.
Put the feed roller in rotation by activating the
green then yellow control pusher located on the
rear left of the branches intake hopper.
Start the shredding.
S T A R T I N G