Glove reference
ScanChain
Available sizes
7/S - 8/M - 9/L - 10/XL
Glove description
Cut-resistant metal mesh gloves
These gloves concern Personal Protective Equipment
items of hazard category II. They meet the requirements
of the regulation 2016/425 and have been subjected to an
EU-type examination performed by:
SATRA Technology Europe, N.B. 2777
Bracetown Business Park,
Clonee, Dublin 15, Ireland
The EU Declaration of Conformity (DOC) can be obtained
through following link: www.scandiagear.com
Applicable standards
These gloves are designed to provide protection against
the hazards associated with the use of hand knives and
blades and with activities such as deboning meat and
working with plastics, leather, and wood.
They were tested and approved to the
relevant paragraphs of the European
Standard EN 1082-1:1996: Protective
clothing - Gloves and arm guards protec-
ting against cuts and stabs by hand knives
Part 1: Chain mail gloves and arm guards.
The gloves were tested to penetration resistance and
tensile strength and passed the minimum performance
requirements.
General information
These gloves can be worn continuously for several hours
and do not contain toxic, carcinogenic, mutagenic, or other
substances that can affect the health or hygiene of the
user adversely. No allergic reactions due to skin contact
with this glove are known.
Protection limit
– Only the metal mesh material of these gloves is cut-
resistant. The levels of performance mentioned are
only valid for: the palms of the gloves and gloves that
are new, unwashed, and in their original condition (i.e.,
have not been repaired).
– These levels of performance were achieved from tests
conducted according to the conditions defined by the
applicable standards.
– Take proper care when working with hand knives,
protection is limited to cuts and stabs.
– Make sure to fit securely (excess of mesh/material can
get caught in moving parts). Glove sizes are indicated
by colour coded straps. The free ends of straps may
need to be shortened to 25 mm or less.
– Due to ageing, wear, environmental factors or
chemicals including oils and solvents, the protection
levels of these gloves may decrease in time. Make
sure to inspect for damages before each time using and
consult your safety responsible manager in case of
doubts about performance.
– If being used in extreme temperatures, we recom-
mend wearing cotton or polyethylene (PE) gloves
underneath. Ensure that the fit remains secure (i.e.,
not loose) and that the strap does not hang longer
than 2.5 cm past the buckle. If creating a proper,
secure fit leads to the strap hanging longer than 2.5
cm past the buckle, please use scissors to cut the
material to a safe, sufficient length.
Please note: while these gloves are ambidextrous,
they are intended for wear on the left hand; see below
illustration for instructions on how to change the strap for
right-hand use.
SCAN
CHAIN
User Instruction
Lorentzweg 31 - 3208 LJ Spijkenisse - The Netherlands
T +31 (0)181 600 955 F +31 (0)181 600 966
E [email protected] I www.scandiagear.com
MARITIME
OUTFITTERS
since 1974
2777
CAT.II
EN 1082-1
:1996
Made with 100% recycled paper
To make sure your chain
mail mesh glove does not
slip during use, we recom-
mend wearing this glove
tightener.
