TS Industrie Super Premium 30ER, Техническое руководство

Страница: 59 / 76

Super Premium 30ER / 35DR / 35DRI
59
23/01/2014
Sensor opening feed for end of chipping
If the user has left the chipper and the time delay ends
whilere there is still material being fed by the belt/roll,
a sensorsensor
(A)
is activated for the opening of the
feed equipment. It prolongs the time delay with the
same amount of time as the setting wheel.
Example : Delay at 1 = 15sec. : the user leaves after
14 seconds while there is still chipping material on
the feed belt. After 15 sec, the sensor will prolong the
maximum speed during another 15 seconds.
Rem:
this system comes into action as branches
of at least 10 to 15 mm in diameter.
D E S C R I P T I O N A N D
Setting sensor
(A), inlet at
the bottom
: 0,40 inch
(A)
Access to the setting wheel:
The wheel numeric is protected
from the weather by a waterproof
cover
The duration of the maximum speed must be
determined by the operator.
(The modification is valid as of
the next start)
Four different configurations are possible, set by means of the
numbers on the setting wheel.
-Shut down contact and choose the working time with the +
and—keys of the setting wheel:
- 1 = 15 seconds at maximum speed
-
2
= 30 seconds at maximum speed
-
3
= 1 minute at maximum speed
- 4 = 2 minutes at maximum speed
(Do not use n° 0 and 5 to 9)
Example : The figure shows program 1, the diesel engine will idle until
15 seconds after the user has left.
Setting wheel