11
12. Connect Power wires.
Connect high voltage wires (110vac) to the wire harness and connector as shown.
Please note that no power should be present.
Power service to this equipment must be shut
off at the main breaker or fuse panel until installation is complete.
13. Turn on Power.
Power to the control panel can now be restored.
Note: Upon power-up the unit should
Close
the window/skylight.
If the window/skylight Opens
,
(Refer to the window crank direction in Step 1a and Dip Switch Settings Step 11)
Disconnect power, change dip switch 3 on S2, reapply power... The window/skylight should now
close.
14. Program Remote Control*.
If optional Hand Held Remote was purchased, it can now be programmed using the “Learn”
button (see No. 7 on wire diagram) Please see the instructions included with the remote.
*If no Hand Held Remote is present on site, skip to Step 15.
