TRUST 532AV POWER VIDEO
25
U K
Windows 98 or
Windows 95 is used.
The software only works correctly
in Windows 98 SE, Windows ME,
Windows 2000 and Windows XP.
The USB port does
not work correctly.
Test the USB port using a different
device or see the USB
troubleshooter at www.trust.com.
The camera has not
been connected to the
computer.
Connect the USB cable.
The error
message ‘Fail
connect to
device, please try
again’ is
displayed after
opening the
Camera Manager.
The window
opens, but I
cannot obtain
files from the
camera’s
memory.
The drivers have not
been installed
correctly.
Uninstall the drivers, remove the
USB cable and reinstall the drivers.
The drivers have not
been installed
correctly.
Install the drivers before
connecting the camera.
The USB port does
not work correctly.
Test the USB port using a different
device or see the USB
troubleshooter at www.trust.com.
The camera is
marked with an
exclamation mark
‘!’ in the Device
Manager.
The camera has been
connected to a USB
hub which does not
have a power supply.
Connect the camera to a USB hub
which has a power supply or to a
USB port on your computer.
The camera’s
webcam mode
does not work.
The PC has a TV
capture card.
There is a conflict
between the camera
and the TV card.
Carry out the following.
1) Remove the TV capture card.
2) Reinstall the camera.
3) Reinstall the TV capture card.
If this does not work, try to reinstall
the drivers for the TV card.
The batteries have
been inserted
incorrectly.
Reinsert the batteries (see chapter
4.3).
The camera is still
connected to your
computer.
Disconnect the USB cable. The
camera cannot be operated when it
is connected to a computer.
The camera is turned
off.
Turn the camera on (see chapter
4.4).
The camera does
not do anything.
The batteries are
empty.
Replace the batteries. This can be
tested by connecting the camera to
the USB port. Something must
appear on the camera’s LCD
screen.
The camera does
not react,
although the
batteries are full.
The camera must be
reset.
Disconnect the USB cable and
remove the batteries from the
camera. Reinsert the batteries after
approximately 10 minutes.
