Trumpf TruTool N 700, Руководство оператора

Страница: 16 / 26

− Hold down the release inhibiter knob (1) and press the
on/off switch (2).
− Release the on/off switch (2).
The switch remains engaged. The motor is running.
or
Ø To switch the machine to instantaneous connection:
− Hold down the release inhibiter knob (1) and press the
on/off switch (2).
− Release the release inhibiter knob (1).
The motor is running.
3. When full speed has been reached: move the machine
towards the workpiece.
4. Machine the desired cutting line.
5. In the event that the cutting track ends in the sheet: pull the
machine (still running) a few millimeters back towards where
the cutting track has already been cut open
6. Immediately press and release the on/off switch (2).
4.2 Changing the cutting direction
In situations where space is limited, the tool can be mounted in
such a way as to have a different cutting direction
■ For cutting profiles: mount the tool at an angle of 90° either
to the left or to the right.
■ For nibbling to the rear: mount the tool at an angle of 180°.
1. Open the locking mechanism (8).
2. Rotate the die carrier (7) in the desired direction.
3. Close the locking mechanism (8).
4. Check the penetration depth of the punch.
4.3 Nibbling with templates
The following requirements must be met when nibbling with tem-
plates:
■ The template must be at least 5 mm thick.
■ There must be a clearance of 11 mm between the contour of
the template and the contour to be nibbled out.
■ The nibbler must be guided in such a way that the exterior
cutout of the punch guide (5) always remains up against the
template.
■ Observe a minimum bending radius of 135 mm.
16 Nibbling with templates 2011-04 E528EN_06
Machining the material
Switching off
deskPDF Studio Trial