Truen TCAM-570-X18H, Руководство пользователя

Страница: 17 / 55

TCAM-570-X18H User Manual
1.3 Megapixel Speed Dome User Manual
17/55
Connecting Power
1. Carefully check the voltage and current capacity of the rated power. The rated power is indicated in
the back of main unit.
2. After confirming the power source, connect power adaptor and connect the 12V DC connector to
the system

For the DC input models, be careful with the polarity of DC power. The system should be
permanently damaged by wrong DC input.

In case that the length of the power wire is very long, there may be voltage drop and the system
may not work properly. Make the length of the power wire as short as possible.
Connecting Network
1. Plug network cable to Ethernet port (RJ-45 network port).
Connecting Video
1. To display video through the composite or HD-SDI port, connect each port to a monitor using BNC
coaxial cable
2. Set Enable Preview option
“ON”
on the Video tab of web page.
(Please refer to the Video Configuration part)

Especially in case of using HD-SDI, video cannot be viewed if BNC coaxial cable is not used.

In case that video transmission distance is long, video data may not be transmitted due to a
reduction in the video signal. In order to prevent it, install a repeater in the middle.

In case of using HD-SDI, video can be viewed only on a HD-SDI monitor.
Connecting Audio
Audio is full-duplex. It is possible to set the mode as Tx-only, Rx-only or Tx-Rx.
1. Connect audio input and output ports to audio devices accordingly.
2. The Audio signal required is line level, so an audio equipment with an amp, mixer or other amplifier
should be used.