TEC_TM_065 REV. B
03/31/2022
Page 33 of 48
TRUE 42 /4 8 INSTALL MANUAL
C A B I N E T S E T U P
DR AWERS
To remove a drawer, pull drawer forward until it stops.
Use a Phillips screw driver to remove the two (2)
screws securing the drawer to the slides, then lift the
drawer up and out of unit. (See Figure 8). To reinstall,
pull drawer slides all the way forward on unit, and then
slide the drawer onto the slides until the hook on the
back of the slide is over top of the drawer, reinstall the
screws using the Phillips screw driver.
FREEZER S TOR AGE
WIRE SHELVES
Remove the top foam piece holding the wire shelves. Carefully remove shelves and set aside. (See Figure 9).
Remove all other packing material. To install, insert wire shelf into the shelf standards on the back wall, with the
front tilted upward, and then lower the front until it stops. (See Figure 10). To remove or adjust a wire shelf, tilt up,
and then lift up and out.
WIRE BASK ETS
To remove a basket, pull drawer forward until it stops.
Use a Phillips screw driver to remove the two (2)
screws securing the basket to the slides, then lift the
basket up and out of unit. To reinstall, pull drawer
slides all the way forward on unit, and then slide the
basket onto the slides until the hook on the back of the
slide is over top of the rails, reinstall the screws using
the Phillips screw driver. (See Figure 12).
FIG. 8.
Drawer slide screw locations.
FIG. 9.
Interior packaging.
FIG. 10.
Hook the shelves into the shelf
standards.
FIG. 11.
Final wire shelf installation.
FIG. 12.
Drawer slide screw locations.
