CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
13
LATERAL TRAINER ASSEMBLY STEPS (continued):
STEP 5: ASSEMBLE THE UPRIGHT TO THE MACHINE BASE (continued):
d
) Slide the Plastic Dome Cover over
the top of the Upright and pull the
wires through the opening. Slide the
Plastic Dome Cover down and latch
it into the Machine Base
e
) Slide the Rubber Dome Cover
Gasket over the top of the Upright
and pull the wires through the
opening. Slide this Rubber Dome
Cover down until it fits firmly into
the Plastic Dome Cover.
NOTE:
The Rubber Dome Cover is
not symmetric and should be
installed in the direction shown.
STEP 5: ASSEMBLE THE UPRIGHT TO THE MACHINE BASE (continued):
f
) Re-route the cables through the
rear opening in the Upright Post as
shown to the right.
The side of the Rubber
Dome Cover circled
below should be in the
back of the machine
Route
Cables
Here
Remove the warning
label after the dome
cover and gasket are
installed.
