LATERAL TRAINER ASSEMBLY STEPS (continued):
STEP 7: ASSEMBLE THE HANDLEBARS TO THE UPRIGHT, CONNECT CABLES:
a
) Hold the Handlebar Grip Assembly
next to the top of the upright and
route cables through both openings in
the upright.
b
) Being careful not to pinch the
wires, slide the Handlebar Grip
Assembly onto the Upright.
c
) Once the Handlebar Grip Assembly
is in place, install 3 bolts and firmly
tighten each one.
Slide Handlebar
wires through
these openings
d)
Connect the Contact Heart Rate
cable to the Combo Heart Rate Board
as shown.
e)
Connect the contact heart rate
cables as shown.
f)
f) Secure the contact heart rate
cables to the upright assembly using
the two zip ties.
CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
15
a)
Place the two bottom console mounting screws inside the bottom
keyholes on the console mast assembly. Partially thread the two top
console mounting screws into the console. Fully tighten all four console
mounting screws.
Note: Ensure all cable connections are routed inside the console mast
assembly to prevent cable pinching.
Note: Refer to the respective console manual included with your console
for wiring connections.
Hardware Required:
Part Number 00567800
,
Qty 4: M5 x 12 bolts
STEP
8
:
CONSOLE ASSEMBLY
:
