Page 23 of 37
5.16 Learning code for remote control on ‘Remocon’ control page
To do learning code for remote control, the user has to go to
‘Remocon’ control page under “CONTROLS” option from the
‘Home’ page.
Please ensure that the device (e.g; Television or fan) should be
turned “ON” when the user do learning code. After turning “ON”,
please do the following procedures.
1)
Click “LEARN CODE” as shown in the picture. Once it is
pressed, it should be highlighted as in ‘Orange’ color.
2)
Click the desired button by user to learn the code. (In this
example, we are learning the code for Television ‘ON’/
‘OFF’ button.)
3)
After clicking the desired button, please point the remote
controller to the middle of IR extender as shown in the
picture and click ‘ON’/ ‘OFF’ button as shown in the
picture. The user will see RED LED is flashing at IR
extender (for about 2 seconds) if learning code is
successful.
It is recommended that the user should point to opposite
direction with the device so as not to have any conflict on
learning the code by IR extender.
4)
Click “LEARN CODE” after the user has done step (3).
“LEARN CODE” button should be grey off as shown in the
picture.
For learning code for other buttons on the remote control
(such as volume up and down, changing channel, etc), the
user has to repeat the above steps with the respective button
the user is desired to register.
Due to the limitation of the interface in the ‘Remocon’
control page, the user can only register up to 6 buttons for
controlling the device, which includes ‘ON’/ ‘OFF’ button.
