Fig. 3-1
Fig. 3-3
IMPORTANT:
The snow thrower is shipped with oil and WITHOUT GASOLINE. After assembly, refer to separate engine manual for
proper fuel and engine oil recommendations.
NOTE:
Remove all loose parts and any packing material before assembling.
NOTE:
References to right or left side of the snow thrower are determined from behind the unit in the operating position.
NOTE:
This Operator’s Manual covers several models, handle
panels, lights and chute cranks are some features that may vary
by model. Not all features referenced (or engines pictured) in
this manual are applicable to all snow thrower models.
NOTE:
Replacement auger shear pins are included with this
manual (or stowed in the plastic handle panel). Refer to Augers in
the Maintainance Section for more information regarding shear
pin replacement.
NOTE:
Some models with electric start are equipped with an
extension cord fastened with a cable tie to the rear of the auger
housing for shipping purposes. Cut the cable tie and remove it
before operating the snow thrower.
Assembling Handle
•
Cut and remove the cable tie holding the chute crank to
the lower handle.
•
Look at the lower rear of the snow thrower frame to be sure
the spring (found at the end of each cable) is attached to
its respective actuator bracket. (Refer to Figures 3-11 and
3-12.)
•
Remove the lower handle knobs, washers and carriage
bolts (and support tubes if equipped) from each side of the
lower handle. See Figure 3-1.
•
Raise the upper handle assembly until it locks over the
lower handle. See Figure 3-2.
•
Secure the upper handle and lower handle (and support
tubes if equipped) with the handle knobs, washers and
carriage bolts previously removed. See Figure 3-3.
•
Tighten the handle knobs already in place on the upper
holes.
•
Remove any rubber bands securing the cables to the wing
nuts.
Fig. 3-2
Assembly & Set-Up
3
7
