5
EN
Operating manual – convector TCH 20 E / TCH 22 E
Assembly
Mounting the feet
Mount the feet before positioning the device.
1. Place the device on its side.
2. Fasten each foot with two screws.
Info
The device offers the possibility of wall mounting. The
holes for wall mounting are situated on the rear of the
device. The accessories for wall mounting are not
included in the scope of delivery.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position or
suspend the device horizontally.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device directly below a wall socket.
•
Make sure that the device cannot come into contact with
moisture or water.
Connecting the power cable
•
Insert the mains plug into a properly secured mains
socket.
•
Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
