Trotec Rayjet 300, Руководство пользователя

Страница: 39 / 40

State Library of Queensland Wiki 35/36 Rayjet 300 Laser Cutter
2019/08/01 08:17 Rayjet 300 Laser Cutter
Troubleshooting
This area is for known issues with the Laser Cutter and how to solve them.
Oval shaped circles
Problem: Circles being cut on the laser are not round but rather a slight oval shape. It is usually
easier to spot on smaller circles.
Solution: Make sure the lens and mirror have been cleaned properly and that the lens has been
fastened. If this doesn't solve the problem the cause is most likely buildup of debris on the track the
lens sits on. If there is any resistance when sliding the lens down the track there is most likely a
buildup. To remove the buildup use an angled awl together with a wet wipe wrapped over it and slide
it up and down the track. you can also use cotton-tip buds but will most likely need something sharp
to get all the way to the back. Rinse and repeat until the lens slides in and out smoothly
Issue #2
Problem: Problem here
Solution: Solution here