7
EN
Operating manual – rotary hammer PRDS 10-230V
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Remove the tool from the tool holder.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Remove the tool from the tool holder.
•
Clean the device as described in the Maintenance chapter.
•
For storing the device, use the transport case included in
the scope of delivery in order to protect the device from
external influences.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
ambient temperature below 40 °C
•
protected from dust and direct sunlight inside the transport
case
Start-up
Unpacking the device
•
Take the transport case out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents of the transport case for completeness
and look for damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
Tool change
The device comes equipped with an SDS-plus system tool
holder.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Please proceed as follows to remove or insert tools:
1. Push the SDS-plus system tool holder (1) to the rear and
hold it there.
2. Insert the tool (e.g. the flat chisel, 10).
1
10
3. Then release the SDS-plus system tool holder (1).
4. Check the tool for tight fit.
Содержание PRDS 10-230V
Страница 1: ...TRT BA PRDS10 230V TC 002 EN PRDS 10 230V EN ORIGINAL INSTRUCTIONS ROTARY HAMMER ...
Страница 16: ......
