Trotec PRDS 10-230V, Оригинальное руководство пользователя

Страница: 13 / 17

EN 12 Operating manual – rotary hammer PRDS 10-230V
ð Operating mode: Chiselling
Info
If the function selector switch with release button (3) is
set to the position and the switch for the impact
mechanism (12) to position , the device is in idle
mode, i.e. there will be no rotation or stroke motion
due to technical reasons.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• If required, allow the device to cool down.
• Remove the tool from the device (see Start-up chapter).
• Clean the device according to the Maintenance chapter.
• Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Accessories Article number
11-piece SDS drill bit and chisel set 6.205.001.101
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Slight smoke or odour are emitted during first use:
• This is not a fault. These phenomena disappear after a
brief runtime.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damages.
• Check the on-site fusing.
Info
Wait for at least 10 minutes before switching the
device back on.
The motor is running, but there is no rotation or stroke
movement:
• Check whether the function selector switch (3) is set to
the position and the switch for the impact
mechanism (12) to position . If so, the device is in idle
mode. For technical reasons there will be no rotation or
stroke motion. Use the two switches (3 and 12) to set the
desired operating mode.