EN
5
radiant heater IR 2000 C / IRS 2010
Warning
Coarse dirt particles on the heating rods can cause the
device to overheat. Fire hazard!
Remove coarse dirt particles from the heating rods
according to the Maintenance chapter before switching
on the device.
Behaviour in the event of an emergency
1. Switch the device off.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
Tilt protection
The device IRS 2010 is equipped with a tilt protection. The tilt
protection is a safety device intended to minimize the risk of fire
in case the device is tipped over inadvertently. The device will
be switched off when knocked over (or if its upright position is
changed in any other manner).
The tilt protection switches the device off when it is inclined out
of its vertical position. The device can again be used as usual
only a few seconds after placing it back in vertical position and
on solid ground.
Information about the device
Device description
The device is used to quickly generate instant heat.
The device is based on the functional principle of heat
generation by infrared radiation, which is generated by a
halogen heating element. The infrared radiation is passed on to
the surrounding surfaces as heat radiation. Persons or objects
are heated directly.
Both heating levels can be selected on the device or by using
the remote control.
•
suitable for roofed and non-roofed outdoor use
•
IP55 type of protection – dust- and water-jet-proof
•
approx. 5,000 operating hours
•
for stand mounting (IRS 2010)
•
for ceiling mounting (IR 2000 C)
•
with tilt protection (IRS 2010)
•
silent operation
•
2 heating levels
•
no dust circulation
