EN
9
radiant heater IR 2000 C / IRS 2010
8. Fasten the mains cable to the foot by means of the two
washers and the four screws.
9. Set the device up in an upright and stable position.
Floor fixing (optional)
Fixing the device is usually not necessary, but improves the tilt
stability if the device is intended to be used permanently in one
place.
1. Set the device up in an upright position. Mark the positions
for the fixing holes on the floor through the holes in the
three fixation plates. Observe the minimum distances to
other objects.
2. Drill the holes into the floor at the marked positions.
3. Place the three wedge bolts into the drill holes and screw
down the three fixation plates in place as indicated.
4. Check the foot for tight fit.
Installation
When installing the device, observe the minimum distances
from walls and other objects as described in the Technical data
chapter.
A
B
C
C
D
D
IR 2000 C
IRS 2010
B
D
C
C
D
•
Never install the device in a way that it radiates directly
onto walls or other objects. Observe the minimum
distances from walls or other objects according to the
Technical data chapter.
•
Do not install the device directly behind a door.
•
Please note that the minimum distance to the front also
applies to objects mounted on the ceiling, e.g. fans, lamps
or sprinkler systems.
•
Do not attach the device IR 2000 C directly below a wall
socket.
•
Do not position the device IR 2010 directly below a wall
socket.
•
Set the device IRS 2010 up in an upright and stable
position.
