EN
7
condenser dryer DH 160 / TTK 1600
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
When positioning the device, keep a sufficient distance to
heat sources.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
When positioning the device, particularly in wet areas,
secure it locally with an RCD (residual current device)
which complies with the respective regulations.
Notes regarding the dehumidification performance
The dehumidification performance depends on:
•
the layout of the room
•
the room temperature
•
the relative humidity
The higher the room temperature and relative humidity, the
greater the dehumidification performance.
For use in living rooms, a relative humidity of approx. 50 to
60 % is sufficient. In storage facilities and archives, the
humidity should not exceed approx. 50 %.
Water discharge
The water condensed on the heat exchanger must be
discharged. This can be done in two ways:
Option 1: via the condensate drain hose connection
Option 2: via the pump drain hose connection
The industrial dryer is equipped with hose connections for hoses
with an inner diameter of 16 mm.
1. Connect a suitable hose to the condensate drain hose
connection (6) or to the pump drain hose connection (7).
Note
Please note that one hose connection is fitted with a
plug.
If necessary, remove the plug from the hose
connection where you want to connect the hose.
6
7
2. Use the plug to close the hose connection that is not used.
