8017 Trotec Speedy
300 fiber
OPERATION
28/07/2015
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
32 / 54
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
4.4 First Steps
To prepare your laser for the first tests, perform the following steps:
1.
Switch machine on with the ON / OFF switch.
The working table automatically references in X/Y/Z direction.
2.
Open the protection cover and place work piece on the working table.
Usually you position the work piece into the upper left-hand corner of the
working table against the horizontal and vertical rulers. However, any
other position on the working table is also possible.
Work pieces, which are larger than 29“ x 17“ / 726 mm x 432 mm can be
processed provided they can be installed and the protection cover can still
be closed properly. Do not try to manipulate the safety system to install
larger work pieces on the system. This could lead to exposure to laser
radiation.
3.
Focus the Laser Beam
For the laser beam in your laser system to be able to process precisely,
the energy is focused with a lens system, which is mounted on the motion
system in a lens holder.
The focusing point of the laser beam (for the high-resolving lens, which is
part of the delivery) is located 8.13 cm (3.2 inch) below the lens.
For optimal processing the surface of the material that you want to
process, must be adjusted to this point.
