8017 Trotec Speedy
300 fiber
SAFETY
28/07/2015
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
10 / 54
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
2 SAFETY
Please read this chapter before operating or servicing a Trotec Speedy 300 fiber laser
system!
2.1 General Safety Information
All personnel involved in installation, set-up, operation maintenance and repair of the machine,
must have read and understood the Operation Manual and in particular the "Safety" section. The
user is recommended to generate company-internal instructions considering the professional
qualifications of the personnel employed in each case, and the receipt of the instruction/Operation
Manual or the participation at introduction/training should be acknowledged in writing in each case.
Safety-conscious Working
The machine must only be operated by trained and authorized personnel.
The scopes of competence for the different activities in the scope of operating the machine must
be clearly defined and observed, so that under the aspect of safety no unclear questions of
competence occur. This applies in particular to activities on the electric equipment, which must
only be performed by special experts.
For all activities concerning installation, set-up, start-up, operation, modifications of conditions and
methods of operation, maintenance, inspection and repair, the switch-off procedures that may be
provided in the Operation Manual must be observed.
Safety Information for the User and/or Operating Personnel
No working methods are permitted that affect the safety of the machine.
The operator must also ensure that no unauthorized persons work with the machine (e.g. by
activating equipment without authorization).
It is the duty of the operator, to check the machine before start of work for externally visible
damage and defects, and to immediately report changes that appear (including behavior during
operation) that affect the safety.
The user must provide that the machine is only operated in perfect condition.
The user must guarantee the cleanness and accessibility at and around the machine by
corresponding instructions and controls.
Principally, no safety components may be removed or disabled (already here we emphasize the
imminent dangers, for example severe burns, loss of eye-sight). If the removal of safety
components is required during repair and service, the replacement of the safety components
must be performed immediately after completion of the service and repair activities.
