8017 Trotec Speedy
300 fiber
SAFETY
28/07/2015
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
12 / 54
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
Dangerous radiation exposure can result from the use of materials other
than described in Section 1.2 Designated Use and the material table in
6.1 Material table:
In case of using highly reflecting materials like
blank or polished metals
metals with very high reflectivity like copper, brass, gold, silver
any materials with highly reflecting coatings
other highly reflecting materials,
especially in combination with high laser power, low processing speed and/or work
pieces with curved or inclined surfaces, laser radiation might be reflected towards
the protection cover. With a very low probability this protection cover could be
damaged if the reflected radiation is FOCUSSED onto the surface of the protection
cover.
Therefore visual inspection for point-like defects on the protection cover should be
done if the aforementioned conditions are given.
The loss of yellow color on the protection cover indicates a damage of the
protecting layer. If you detect such effects, immediately turn off the laser machine
and take care to get a new protection cover.
Also other components inside the machine may be damaged if the aforementioned
conditions are given.
To improve laser safety an optional “Laser Protection Cover” is
available on request.
