Leveling
：
Standard sheet of A4 paper, allen wrench (3mm), resin vat and
printing platform not installed. The print platform
⑬
is locked place when
shipped, need to loosen the level jackscrew (4), to allow the platform move.
①
Clear the print area first, then click return home
②
Place the A4 paper on the printing area, and then install the printing
platform, as shown in FIG. (4). Tighten the carriage lock handle and pull
A4 paper
，
If the paper can be easily pulled, the platform is high,
according to the steps (3) operation
；
If it can not be pulled, then the
platform is low, adjust according to the step (3) operation
；
If the
tightness is appropriate, adjust the platform to be parallel to the edge
line, as shown in figure (5). Tighten the top jackscrew to print.
③
The platform is high
，
click
(Do not select other gear values to
prevent damage to the 2K screen
）
,then click
（
one time click
）
，
Pull A4 paper, repeat this step as many times until there is slight
resistance when the paper is pulled, adjust the platform to be parallel to
the edge line, and tighten the jackscrew.Back to click
reset zero
，
click to select
，
as FIG
（
6
），
till finished leveling
。
（
At this point, the
mechanical zero is not the same position as the reset zero, and the reset
zero is the starting position of printing
）
①
②
First put
paper(1), and
then install
platform (2),
so as not to
scratch the
steel film
FIG
（
4
）
FIG
（
6
）
FIG
（
5
）
8
