Troubleshooting
：
1. The model won't stick
：
①
Bottom exposure time is too short, lengthen the
bottom exposure time and the number of layers
②
If the top jackscrew of the platform is loose or not
adjusted and leveled, re-adjust and tighten it
③
When slicing, the bottom of the model was not
placed on the platform, and the model was
suspended, need to slice again
2. Model printing is incomplete and missing:
①
The model itself has a dangling part, and the lack of
support leads to incomplete printing
②
Adding too little support or too thin support results
in adding support or selecting a thicker type of
support
③
Model testing needs to be replaced because of
problems with the model itself
④
Due to too few contact surfaces between the model
bottom and the platform, the bottom raft needs to
be added
