Tronix Explorer XT3, Руководство пользователя

Страница: 7 / 16

Operation
1. Charge Explorer XT3 as instructed in Installation .
2. Set up the necessary lighting equipment.
3. On the front panel, connect the plug of the flash unit to one of the sockets of Explorer XT3.
For 115-60 models, a universal adapter is supplied.
Note: The connections between the flash units and Explorer XT3 must be in close proximity
and must be easily accessed.
4. Switch on Explorer XT3.
The battery level indicators ( green High , yellow Mid and red Low ) indicate the amount of
power left in the battery. Explorer XT3 is now supplying power to the flash units.
5. Test the flash units. If the desired lighting requirements are set, proceed with the photo
shoot.
6. To conserve battery, switch off Explorer XT3 when the flash units are not in use.
Note: Using the modeling lamps in flash units will prolong recycling time and will quickly
discharge the battery. Therefore, it is advised not to use modeling lights when using
Explorer XT3 as power source.
Optional: For additional safety, connect the earth stud of Explorer XT3 to earth.