Troubleshooting
Refer to the table to address minor problems regarding installation and operation of Explorer XT3.
For other problems, contact Tronix Customer Service (see
Contact Information
).
Problem
Possible Cause
Solution
No power
Battery empty
Connected to AC outlet
Charge Battery; Plug Explorer XT3 to a 100 V to
240 V AC outlet or to a 14 V DC supply. If Explorer
XT3 does not switch on after charging, contact
Tronix Customer Service (see
Contact Information
)
Explorer XT3 does not provide power when switched
on while connected to an AC outlet. Disconnect the
AC cord before using
Not charging
Not plugged to supply
No power from outlet
Plug Explorer XT3 to a 100 V to 240 V AC outlet or
to a 14V DC supply
Ensure power is in the mains outlet. If Explorer XT3
still does not charge, contact Tronix Customer
Service (see
Contact Information
)
Lighting
equipment
not working
Battery not charged
Lighting equipment
malfunction
Incompatible equipment
Charge Battery; Plug Explorer XT3 to a 100 V to
240 V AC outlet or to a 14V DC supply
Contact manufacturer of lighting equipment
Lighting equipment not compatible with Explorer
XT3 (see
Compatibility Chart
for compatible
equipment)
Battery draining
fast
Battery not fully
charged
Modeling lamps in flash
units
Battery nearing end of
its useful life
Charge battery for 3 to 5 hours (12 to 15 hours if
charging for the first time)
Modeling lamps, when used with flash units, drains
the battery faster. It is not advised to use modeling
lamps with Explorer XT3 as power source
Battery performance decreases with time. Also,
batteries age prematurely when placed in places
with high temperatures. Replace battery. See
Battery Replacement
No power; All
three LEDs lit
Overload or short circuit
of output has occurred
Check output for short circuit and power on the unit
again
Содержание Explorer XT3
Страница 1: ...USER S GUIDE ...
