WWW.AWC608.COM
being set back to the original dir
3) After power-on, press the stop button to stop all axis resets,
enter the power-on reset settings in the manufacturer parameters,
turn on all required axis power
unnecessary axis power
4) According to the actual installed limit switch, find the coordinate
map of the relative plane system, and enter the return test
interface.
1) Press the XY reset button to observe whether the direction of
the return to the origin of each axis is corre
incorrect movement then Stop, find the direction of the
corresponding axis on the panel to modify the direction of origin
respectively, correct movement axis no need to revised, incorrect
one need to be set as opposite on the wrong
test interface again, press the XY reset button to ensure that the XY
reset.
2)Back to the return test interface, click UD1 to reset, observe
whether the returning direction of the UD1 axis is correct, press the
stop key If there is any axis incorrect movement immediately, find
the returning direction modification of the corresponding axis on the
panel, Set to the opposite based on the original direction, enter the
return test interface again, press the UD1 reset key to ensure that
the UD1 reset is normal
3) commissioning other required axes in the same way.
4) Return to the main interface, press the reset button and wait for
all axes to reset. All axes can only be moved by the arrow keys
when the normal reset is completed. Those
Motion controller user manual
being set back to the original direction and damaging the blade
on, press the stop button to stop all axis resets,
on reset settings in the manufacturer parameters,
turn on all required axis power-on resets, and turn off other
unnecessary axis power-on resets.
4) According to the actual installed limit switch, find the coordinate
map of the relative plane system, and enter the return test
1) Press the XY reset button to observe whether the direction of
the return to the origin of each axis is correct. If there is any axis
incorrect movement then Stop, find the direction of the
corresponding axis on the panel to modify the direction of origin
respectively, correct movement axis no need to revised, incorrect
one need to be set as opposite on the wrong basis, enter the return
test interface again, press the XY reset button to ensure that the XY
2)Back to the return test interface, click UD1 to reset, observe
whether the returning direction of the UD1 axis is correct, press the
s any axis incorrect movement immediately, find
the returning direction modification of the corresponding axis on the
panel, Set to the opposite based on the original direction, enter the
return test interface again, press the UD1 reset key to ensure that
the UD1 reset is normal
3) commissioning other required axes in the same way.
4) Return to the main interface, press the reset button and wait for
all axes to reset. All axes can only be moved by the arrow keys
when the normal reset is completed. Those that do not complete
TC-6832
Motion controller user manual
27
ection and damaging the blade
on, press the stop button to stop all axis resets,
on reset settings in the manufacturer parameters,
on resets, and turn off other
4) According to the actual installed limit switch, find the coordinate
map of the relative plane system, and enter the return test
1) Press the XY reset button to observe whether the direction of
ct. If there is any axis
incorrect movement then Stop, find the direction of the
corresponding axis on the panel to modify the direction of origin
respectively, correct movement axis no need to revised, incorrect
basis, enter the return
test interface again, press the XY reset button to ensure that the XY
2)Back to the return test interface, click UD1 to reset, observe
whether the returning direction of the UD1 axis is correct, press the
s any axis incorrect movement immediately, find
the returning direction modification of the corresponding axis on the
panel, Set to the opposite based on the original direction, enter the
return test interface again, press the UD1 reset key to ensure that
3) commissioning other required axes in the same way.
4) Return to the main interface, press the reset button and wait for
all axes to reset. All axes can only be moved by the arrow keys
that do not complete
