Triumph Tiger XCX, Руководство пользователя

Страница: 58 / 172

General Information
58
An alternative way to increase the
speed in cruise control is to accelerate
to the desired speed using the throttle
grip and then press the SET/- adjust
button.
Decreasing Speed while in Cruise
Control
To decrease speed, press and release
the SET/- adjust button. Each press of
the button will decrease the speed by
1 mph or 1 km/h. If the button is held, the
speed will continuously decrease in
single digit increments.
While decreasing the speed, the display
screen in the instruments will change to
SEt and will show the new speed.
When the desired speed has been
achieved, release the adjust button.
After four seconds the display screen
will change to the previous display.
Deactivating Cruise Control
The cruise control can be deactivated by
one of the following methods:
• Roll the throttle twist grip fully
forward
• Press and release the ON/OFF
button on the right hand switch
housing
• Pull the clutch lever
• Operate the front or rear brake
• Increase speed by using the throttle
grip for more than 60 seconds.
Provided the cruise control has not been
deactivated by turning the ignition
switch to the OFF position, the previous
set speed can be resumed by pressing
and releasing the RES/+ adjust button.
The motorcycle speed has to be between
30 to 100 mph (48 to 160 km/h) and in
4
th
gear or higher.
Ignition
Ignition Key
1. Key number tag
In addition to operating the steering
lock/ignition switch, the ignition key is
required to operate the seat lock and
fuel tank cap.
When the motorcycle is delivered from
the factory, two keys are supplied
together with a small tag bearing the
key number. Make a note of the key
number and store the spare key and key
number tag in a safe place away from
the motorcycle.
There is a transponder within the key to
turn off the engine immobilizer. To
ensure the immobilizer functions
correctly, always have only one of the
ignition keys near the ignition switch.
Having two ignition keys near the switch
may interrupt the signal between the
transponder and the engine immobilizer.
In this situation the engine immobilizer
will remain active until one of the
ignition keys is removed.
ceom
1