!!
!
!!
!
!!
!
Maintenance and Adjustment
Page 78
Headlight/Position
Light Bulb Replacement
It is not necessary to remove the headlight
to gain access to either bulb.
•
Remove the front seat.
•
Disconnect the battery, negative
(black) lead first.
•
Remove the cockpit infill panels to
allow access to the position lamps.
See ’Fuses’
.
•
To remove the position light bulb,
disconnect the multi-plug then pull
the bulb holder (NOT the wires) until
it is released from the housing.
•
To remove the bulb from the holder,
gently pull on the bulb until it is
released.
•
To remove the headlight bulb,
disconnect the multi--pin electrical
connector from the headlight bulb and
remove the rubber cover.
•
Detach the wire bulb retainer from the
clip. It is not necessary to undo the
screw.
•
Remove the bulb from the headlight.
•
Installation for both bulbs is the
reverse of the removal procedure.
CAUTION:
When
reconnecting
the
battery,
connect the positive (red) lead first.
WARNING: Do not reconnect
the battery until the assembly
process
has
been
completed.
Premature
battery
reconnection
could result in ignition of the battery
gases causing risk of injury.
1. Headlight Bulb Retainer
2. Position Light
WARNING:
The
bulb
becomes hot during use.
Always allow sufficient time for the
bulb to cool before handling.
Avoid touching the glass part of the
bulb. If the glass is touched or gets
dirty, clean with alcohol before
re--use.
