Triton Zante, Инструкция по установке и эксплуатации

Страница: 16 / 29

Zanté electric shower
OPERATING THE SHOWER
To start the shower
Press the ‘START/STOP’ button and water will
flow.
To stop the shower
Press the ‘START/STOP’ button and water will
cease to flow.
To use the power selector
The power selector has three positions — cold,
economy and high
(fig.) .
Blue symbol is COLD water only. Adjustment
of the temperature control at this setting will
only alter the force of the water from the
showerhead. IT WILL NOT ALTER THE WATER
TEMPERATURE.
Semi red symbol
is an ECONOMY setting
for using less power when the ambient mains
water temperature is high during hot months.
Temperature adjustment at this setting is via the
temperature control.
Note: If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
Full red symbol
is a HIGH setting which
allows the highest flow achievable for your
preferred temperature. This setting should
normally be regarded as optimum shower
Start/Stop
button
Temperature
control
Power
selector
Economy
Cold
High
Fig.
WARNING!
before normal operation of the
shower, it is essential that the
commissioning procedure has been
completed correctly.
Note:
In normal use, it is in order to leave
the water supply permanently on to the
shower unit, but as with most electrical
appliances,
the unit must be switched
off at the isolating switch when not
in use
.
WARNING!
If restarting immediately after
stopping, be aware that a slug of hot
water will be expelled for the first few
seconds.