Triton Topaz T80si, Инструкция по установке и эксплуатации

Страница: 13 / 24

T 8 0 s i
11
rail and secure the bracket to the wall with
the screws supplied (fig.21).
E Place a trim cover onto each bracket
ensuring the large protrusion at the narrow
end of the trim cover, engages into the slot
between the rail and bracket (fig.22) before
pushing and clicking the other end into
place (fig.23). Should the need arise, the
trim covers can be removed by inserting a
screwdriver into the slot and carefully
levering off the trim.
F Snap the soap dish onto the rail (fig.24)
below the holder assembly. Prise open the
soap dish collar and fit onto the rail (fig.25)
below the dish. Note the collar is slightly
tapered and should be fitted ‘thinner
section’ uppermost. Ensure it locates firmly
in the soap dish (fig.26) so that it holds the
dish at the required height on the rail.
FITTING THE HOSE AND SPRAYHEAD
Feed the flexible hose through the
appropriate soap dish aperture (fig.27) in
order that the dish acts as a retaining ring
(Water Supply Byelaw 17).
Screw the flexible hose to the shower outlet
and sprayhead (fig.28) ensuring the supplied
washers are in place at both ends of the
flexible hose.
Place the sprayhead into the holder (fig.29)
and check that it fits correctly. NOTE: The
holder is slightly tapered and the sprayhead
and hose will only fit from one direction.
Important: It is the conical end of the hose
which grips into the holder. The sprayhead
will not fit in the holder without the hose
attached.
Thin section at top
Collar
Fig.26
Fig.27
Spr ayhead
Holder
Washers
Shower
Sprayhead
Fig.28
Fig.29
Fig.25
Fig.24