Spellbind
20
Phased shutdown
During use, when the START/STOP button is
pressed, power is switched off to the elements
and the power indicator will extinguish. The
display will change to a flashing ‘SD’. Water
continues to flow for a few seconds, flushing
out any remaining hot water. This makes sure
the next immediate user will not receive a slug
of hot water if standing under the showerhead
when starting the shower.
Safety cut-out
The shower is fitted with a thermal cut-out safety
device. In the event of abnormal operation
which could cause unsafe temperatures within
the unit, the device will disconnect the heating
elements.
It will require a visit from a qualified engineer to
determine the nature of the fault and replace the
safety device, once the unit has been repaired.
W-002-A
WARNING!
After any servicing of mains water
supply, always flush out the pipework
to remove any debris.
Always make sure the unit is started
on COLD in order to purge any air in
the pipework.
Fig.35
Five showerhead patterns are available
(fig.35)
.
Adjust the spray pattern by turning the bezel
on the showerhead in either direction until the
desired pattern is obtained.
Adjusting the showerhead
ADJUSTING THE SHOWERHEAD
