Spellbind
10
After choosing the site for the shower, use the
backplate as a template and mark the three wall
fixing holes
(fig.11)
.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Screw the top left-hand fixing screw into
position leaving the base of the screw head
protruding 6 mm out from the wall.
Hook the backplate over this screw, then fit the
other two fixing screws into position.
DO NOT fully tighten the screws at this stage,
as the fixing holes are elongated to allow for
out of square adjustment after the plumbing
connections have been completed.
WARNING!
If using a silicon seal around the
backplate edge, make sure the PRD
exit behind the outlet pipe is kept
clear (fig.7).
