Manual mixer shower
8
IMPORTANT:
Make sure that all the supply
pipework has been flushed through before
fitting the mixer
(fig.11).
Fitting to the wall
Fit the trim onto the inlet water pipes followed
by the nut and olive
(fig.12)
.
Connect the hot water supply to the inlet
marked
HOT
, ‘
H
’ or red/orange label and
connect the cold water supply to the inlet
marked
COLD
, ‘
C
’ or blue label
(fig.12)
.
Tighten all compression fittings.
Tighten all the grub screws to secure the mixer
to mounting plate.
FITTING THE CONTROL LEVER
Push the control lever onto the valve. Using
an Allen key, secure the lever to the valve by
tightening the screw on the underside of the
lever and fit the trim
(fig.13)
.
COMMISSIONING
Check that both hot and cold water supplies
are fully open and at (or near to) their design
temperature and pressures are within the
requirements as stated.
Check the mixer can supply the maximum hot
and maximum cold water demands.
HOT
COLD
Trim
Nut
Olive
Fig.12
Grub screw
in recess
Fig.13
Fig.11
