Manual mixer shower
7
FITTING THE MIXER
Mark the position of the four locating screws
for the mounting plate, although if installing to
a solid brick wall, using two diagonal holes will
usually be enough.
Drill and plug the wall. An appropriate drill bit
should be used. If the wall is brick, plasterboard
or a soft building block, appropriate wall plugs
and screws should be fitted.
Fit the mounting plate onto the wall
(fig.8)
.
The inlet elbows allow for either rising, falling
or rear entry hot and cold water supplies. The
elbow adapters have two ‘O’ ring seals
(fig.9)
to
the body and do not require PTFE tape or other
means of sealing. The elbows each have a grub
screw that will need tightening once the mixer
is fitted to secure them to the elbow adaptors
(fig.9)
.
Bottom to top outlet change
Note:
The outlet plug and adapter positions
can be changed to accommodate top or bottom
outlet
(fig.10)
.
DO NOT
rotate the mixer valve.
Fig.8
Fig.9
O ring
Elbow
Elbow
adaptor
Grub
screw
Fig.10
