Bar Mixer Shower
14
Push each pipe into the wall until it stops against
the depth of chasing. Measure 29mm from the
face of the finished wall or tiles and mark the
pipe.
Using a pipe cutter, cut the pipe at the 29mm
mark and deburr.
IMPORTANT:
When the pipework is at rest
against the depth of chasing the length
of pipe protruding from the wall should
be between 30mm MAXIMUM and 28mm
MINIMUM from the face of the finished wall
or tiles
(fig.15)
.
Make sure the outer surface of the pipes are
clean and free of any debris or damage. Clean
the surface if necessary.
IMPORTANT: Press a push-fit
connector onto each pipe until
the pipe is pushed past the
‘O’ring and reaches the stop
within the connector. This can be
visually checked by viewing the
pipework through the push-fit
connector outlet (fig.16). Insert
locking clips onto hot and cold
water push fit connections.
Fitting the Mounting Plate
Ensure that the locking clips are in place before
starting this procedure.
Screw the mounting plate onto the push-fit
connector until it
reaches the stop
and begins
to turn the connector itself
(fig.16a and b).
T00358
Maximum
30 mm
Minimum
28 mm
Finished
surface
T00358
T00360
Fig.15
Fig.16
T00365
Fig.16a
T00358
Fig.16b
