Triton DC7000 Antique, Инструкция по установке и эксплуатации

Страница: 12 / 28

DC7000 ANTIQUE
10
c) Valve installation in a hollow wall
The wall mounting bracket supplied with the
shower is suitable for use on a plasterboard wall
of 10mm - 13mm thickness.
Decide on the shower position and determine
whether the hot and cold water supplies will enter
the shower from the top (falling) or bottom
(rising) or rear.
The hollow cavity should be at least 65mm deep
from the surface of the wall. It is recommended to
use the supplied mounting bracket (fig.10) at all
times when installing the shower valve. It provides
the correct visible amount of shower control
through the face plate when the installation is
complete. There is limited tolerance between the
control knobs and trim rings to allow for varying
thickness of tiles up to 10mm.
Mark the route of the incoming and outgoing
pipework. As a guide for the size of hole, place
the tile shroud on the wall and trace around it
(fig.11).
Take out the plasterboard and offer the mounting
bracket up to the wall and mark the four outer
plain holes (fig.13). Remove the bracket and drill
the wall.
Two additional flat brackets are supplied for
hollow wall fixing. Slide the ‘T’ piece section
through the slot either side of the mounting
bracket then insert it into the wall cavity and
position the two flat brackets in line with the
outer holes (fig.14). Secure using the bolts
provided. Route the pipework to the valve
position.
Flush out the pipework in accordance with
Water Regulation Byelaws .
Offer the valve up to the mounting bracket and
secure using the four screws provided.
Proceed to ‘connecting supply pipes’ section.
Flat bracket
positioned inside
of panel
Fig.13
Fig.14