Triton AS2000X, Инструкция по установке и эксплуатации

Страница: 18 / 28

Aquasensation AS2000X
16
Washers
Shower
Showerhead
Showerhead
Holder
To remove a trim, push a small screwdriver or
similar through the slot in the trim end and
carefully pull away from the wall bracket.
Slide the soap dish down the rail so that its
bracket engages on top of the lower finishing
trim.
Adjusting the showerhead holder
To adjust the height, press the button
underneath the holder
to release the locking
mechanism (fig.36) . Still pressing the button,
move the holder up or down to suit user’s
requirement.
Fitting the hose and showerhead
Feed the flexible hose through the soap dish
aperture
(fig.37) so the dish acts as a retaining
ring (Water Regulations).
Screw the flexible hose to the shower outlet and
showerhead, checking the supplied washers
are in place at both ends of the flexible hose
(fig.38) .
Place the showerhead into the holder and check
that it fits correctly
(fig.39) .
Note: The holder is slightly tapered and the
showerhead and hose will only fit from one
direction.
IMPORTANT: It is the conical end of the hose
which grips into the holder. The showerhead
will not fit in the holder without the hose
attached. At this stage, disconnect the
showerhead and lay aside until the shower
unit has been commissioned.
CAUTION: This appliance is not intended
for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of
the appliance by a person responsible for
their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Fig.35
Fig.37
Fig.39
Fig.36
Fig.38