Triton AS2000X, Инструкция по установке и эксплуатации

Страница: 17 / 28

Aquasensation AS2000X
15
*FITTING THE RISER RAIL
Decide the position for the rail on the wall within
the shower area. Proceed as follows:
Fit the showerhead holder onto the riser rail.
The correct orientation of the holder is when the
showerhead holder is sloping DOWN
(fig.30) .
To fit the showerhead holder onto the riser
rail unit, press and hold the button on the
underneath of the showerhead holder to release
the locking mechanism, then slide onto the rail.
Slide the supplied soap dish onto the riser rail
below the showerhead holder
(fig.31) .
Slide the top and bottom finishing trims onto the
riser rail
(fig.32) .
Push the two fixing brackets into the ends of the
riser rail
(fig.33)
.
Offer the rail assembly to the wall (fig.34) .
Using the brackets as templates, mark two upper
holes and two lower holes. Note there are four
provisions for screws per bracket – select the two
most suitable for your requirements. Make sure
the rail is aligned vertically.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Screw to the wall.
Slide the finishing trims onto the brackets. Make
sure the lug on each rail bracket end engages
into the slot on the fatter end of each trim before
push fitting the thinner ends in place
(fig.35) .
WARNING!
Check there are no hidden cables or
pipes before drilling holes for wall
plugs. Use great care when using
power tools near water. The use of
a residual current device (RCD) is
recommended.
Fig.33
Fig.30
Fig.32
Fig.31
Fig.34
*
All kits are for illustration purposes only and are not
supplied unless otherwise stated.