-
１０
- XM010-V1.4-NR
channel number. In other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set a different address, each unit will start to “listen” to the channel number you have set,
based on the quantity of control channels of the unit. That means changing the settings of one
channel will affect only the selected fixture.
In the case of the spot head, which is a 17 channel fixture, you should set the starting address of the
first unit to 1, the second unit to 18 (17 + 1), the third to 35 (18 + 17), and so on.
Note:
After switching on, the machine will automatically detect whether DMX 512 data is received or not. If the data is
received, the display will show
"A.001"
with the actually set address. If there is no data received at the
DMX-input, the display flashes
"A001"
with the actually set address. This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the machine.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap in the
input connector.
Control Board
The Control Board offers several features: you can simply set the starting address, switch on and off the lamp, run
the pre-programmed program or make a reset.
The main menu is accessed by pressing the Mode/esc-button until the display starts flashing. Browse through the
menu by pressing the
Up
-button or
Down
-button. Press the
Enter
-button in order to select the desired menu. You
can change the selection by pressing the
Up
-button or
Down
-button. Confirm every selection by pressing the
Enter
-button. You can leave every mode by pressing the
Mode/esc
-button. The functions provided are described in
the following sections.
