Triple E EMPRESS SERIES, Руководство пользователя

Страница: 71 / 133

9-3
EMPRESS
Make sure travel locks are removed be-
fore extending the slide-out.
Make sure travel locks are fastened se-
curely before moving the motorhome.
WARNING
IMPORTANT
The hydraulics that operate the slide-out
are run by a 12-volt pump. When operat-
ing the slide-out, make sure your batteries
are fully charged or you are hooked up to
120 volt power. You may also choose to
use the Power Generator on your mo-
Make very sure that everyone is standing clear of
the interior and exterior path of the slide-out as
you extend and retract it.
WARNING
CAUTION
Never move your motorhome with
the slide-out extended. Severe dam-
age could result. Before moving the
motorhome, the slide-out must be
securely retracted and all travel locks
fastened.
3.
To Extend:
With the leveling jacks extended and the unit
secured and level turn the control panel power
lock key to “on’, press and hold the control
switch located above the entrance door until it
is fully extended. Make sure it is fully extended
so that all weather seals will be in their proper
alignment.
4.
To Retract:
Be sure that there are no obstructions inside or
outside the motorhome that would prevent easy
operation. Turn ignition to accessory position
and turn the jack control panel on. Press and
hold the control switch on the slide out control
until the room is back in place. Install the travel
locks and prepare the rest of the motorhome for
travel. Turn key switch on the slide out control
to the off position and remove the key.
5.
Set-Up:
Set-up by a professional, adjustments, regular
maintenance and replacement of weather seals
as needed will extend the life and comfort of
your slide-out unit.
6.
Seals:
Cracked and worn weather seals may allow
moisture and dirt to enter your motorhome and
cause premature deterioration of the interior.
Check the seals carefully in fall and in spring
and have them replaced if necessary.
Extensive travel and use in severe weather
conditions may cause a more rapid deterioration
of some components, especially weather seals.
In some circumstances these may need to be
replaced.