TrinityHighway.com
29
Created November 2021
STEP 12
SRT™ Anchor Cable Assembly
PARTS
INSTRUCTIONS
N
3000G
1 EA
1. Assemble the SRT™ Anchor Cable (Part N) as shown above.
2. Ensure the bent part of the SRT™ Cable Anchor Bracket Angle (Part Q) at
SRT™ Anchor Post is up and hooked over the CR Post 1 Top.
3. While tightening nut with a wrench, restrain the cable with locking pliers at
the end being tightened to avoid twisting the cable.
4. Tighten the cable until it is taut. The cable is considered taut when it does not
deflect more than 1 inch [25 mm] when pressure is applied by hand in an up
or down direction.
Q
33909G
1 EA
T
3910G
2 EA
V
3900G
2 EA
Use only Trinity Highway parts that
are specified herein for the SRT™
31
System
for
assembling,
maintaining, or repairing the
SRT™ 31 System. Do not utilize
or otherwise commingle parts from
other systems even if those
systems are Trinity Highway
systems.
WARNINGS
Ensure the cable is taut. Failure to follow this warning could result in
serious injury or death in the event of a vehicle impact with the
system.
Ensure the bent part of the SRT™ Cable Anchor Bracket Angle at
SRT™ Anchor Post is up and hooked over the CR Post 1 Top.
